Maintenance Manual for 10kW Israel Telecommunications Power Supply Cabinet

Q: How do I maintain the isolation of the power supply?

To maintain the isolation of power supply and prevent ground loops, use an isolated programming source when operating the power supply via Remote Analog programming at the J1 connector. Turn the AC On/Off power switch to the OFF position.

4 FAQs about Maintenance Manual for 10kW Israel Telecommunications Power Supply Cabinet

Where can I find the installation and operating manual 610 551431 en 3?

610 551431 EN 3 AR NL DE PL PT ES RU HU SL FR IT TR LT EN RO Download last release of installation and operating manual from: The safety information in this manual should be retained for future reference. The reference information on safety is in English.

What voltage does a Genesys 10kW 15kW power supply use?

The GenesysTM Series 10kW/15kW power supply can be operated from a nominal three-phase 208VAC, 400VAC or 480VAC, 4 wire, 47–63 Hz AC input. The AC input voltage range and current required for each model is specified in Chapter 2, Section 2.2 (Input Characteristics).

How to set up two-wire a 10kW / 15kW model?

Use the “Two-Wire” method for 10kW/15kW Models where 25V < Vout ≤ 600V. 6.2.1. Basic Parallel Operation In this method, setting the units as Master and Slaves is made by the rear panel J1 Remote Analog connections and the setup switch SW1.

How do I maintain the isolation of the power supply?

To maintain the isolation of power supply and prevent ground loops, use an isolated programming source when operating the power supply via Remote Analog programming at the J1 connector. Turn the AC On/Off power switch to the OFF position.